Solve the problem that X431 PAD cannot charge power
1, Use “AutoUdiskBoot_en.GHO” to make the U disk start HDD.
2, Copy all file of content?EC130220 to the Root directory of?U disk start HDD you made on last step (it will pop up tips of?File Replace dialog box, then click “OK” to confirm, then replace the file).
3,Equipment shutdown state, connect U disk start HDD, USBKeyboard and power adapter (Must).
4,Boot this device and press button “Delete” of keyboard at the same time (keep pressing it)until you enterBIOS settings interface.
5,Set startup mode as U disk boot mode
1)After entering the BIOS setup screen, you can see the menu bar at the top of the screen:
Main Advanced Chipset Boot Security Save Exit
2)Use left and right arrows can be switched between different menu bar:
To set the U disk, need to select the “Boot” menu bar;
3)After enter the “Boot” menu bar it will show the following options?(you can use up and down arrows to select)
4) Use the down arrow to select “Hard Drive BBS Priorities”, and then enter into the boot selection menu items;
5) After entering the start menu items shown below:
6) Press on the keyboard in the 5) menu “-” button to switch the startup mode;
7）Then press F10, Enter key, then save the BIOS settings and restart (do not pull out U disk).
6,After the restart, ?burn will be?performed automatically;
7,Wait until burn programming process is completed, then it will automatically shut down upon completion;
8,Re-boot, follow the steps above 3,4 operation, enter the BIOS setup, then change “Boot” boot order back to electronic drives priorities (as shown below), save the BIOS settings and restart;
9,Burn completed
Auto diagnostic obd Vagcom 12.12 diagnostic interface vag com 12.12 software install guide
Step 1. Drivers path: C:Ross-TechVCDS
Step 2. Computer time into 2013.10.1 (each software prompts to change the system time expired are to this time), turn off all network connections.
Step 3. Please never connect it to Internet and update the software.(only use this CD-ROM softwares)
Step 4. To avoid loss and damage of software data, please dont pull up and plug USB and OBD port during the use(open the software and communications within car).
Step 5. Please make sure all the antivirus programs are closed before using, it is very important.
