How to Setting or Testing the ENGINE OVERSPEED using CAT ET?
Here the STEPS;
1. Connect CAT ET Software, click on menu “Service” then “Monitoring System”.
Read More: How to Connect CAT Caterpillar ET Software from your Laptop to ECM
2. Just to make sure, before setting up the Monitoring System, need to set “Unlocked” on Monitoring System Configuration Access, through menu “Service” then “Parameter Lockout”.
3. Back to Monitoring System, click on “Engine Overspeed”. Change the Monitor System for Engine Speed, by editing on Trip Point (RPM): 1800-2600 RPM.
4. For example: set Trip Point to 1800 RPM, then try to testing the Engine Overspeed while engine is running. When Engine RPM reached 1800 RPM, the Engine should be shutdown suddenly (the ECM will activated the ASO valve), with Diagnostic Code: SPN190 – FMI0.
Read More:
FREE Setting CAT ET-2018C Full Service Dealer, Diagnostic Software for Caterpillar Engine
FREE Setting CAT ET-2019A Full Service Dealer, Diagnostic Software for Caterpillar Engine
NOTE:
MONITORING SYSTEM:
-Engine Overspeed
-High Auxiliary Pressure
-High Auxiliary Temperature
-High Engine Coolant Temperature
-High Engine Inlet Air Temperature
-High Fuel Filter Pressure Restriction
-High Fuel Pressure
-High Fuel Temperature
-Low Coolant Level
-Low Engine Oil Pressure
Read More:
How to setting new CAT Messenger Display
Change Units of Measure on CAT Messenger Display
Change Measurement System on Caterpillar ET Software
